H Block" Roller (Media Separator) - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Standard Feeder (WF9S) Parts Removal
5.25 "H Block"
Roller (Media
Separator)
on Standard
Feeder
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
1. Remove "H" block by lifting up tab and sliding assembly up and out.
2. Slide the blue ring to the lock position for the H block roller. Unfasten
shoulder screws (one on either end) to remove H block roller. The shaft
and separators will drop off the H block. Remove the H block roller from
the shaft.
Shoulder
"H" Block Roller
Screw
3. Reinstall in reverse order. NOTE: The installation of the new assembly
and may require a strong push down on the H block roller.
Removal and Replacement • 5
"H" Block
Blue Ring to
Lock Roller
Shoulder Screws
Removed
5-43