Entry Roller Support Assembly - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Printer Parts Removal
5.32 Entry
Roller Support
Assembly
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
1. Remove top cover (see section 5.x).
2. Remove the front cover assembly (see section 5.29) and rear cover (see
section 5.30).
3. Unfasten the six screws (three on either side, see figure below) and re-
move the entry roller support frame and assembly.
Idler Roller Pivot Arm
3. Unfasten the e-clip on either side for idler roller pivot shaft if you need to
remove and replace shaft (see above).
4. Unfasten the two screws (one on either side) of the idler roller pivot arm
and remove the entry idler roller from the idler roller pivot arm (see figure
below).
5. Peel the o-ring off the roller.
O-Ring
Entry Idler Roller
7. Reinstall in reverse order.
Removal and Replacement • 5
Entry Roller Support Frame
E-clip for Idler Roller Pivot
Shaft (shows one side only)
Screws for Entry Roller Support
Frame (shows one side only)
Entry Roller Support Frame
and Assembly (removed)
Screws for Entry Idler Roller
Idler Roller Pivot Arm
5-55