Pitney Bowes DA80F Service Manual page 122

5 • Removal and Replacement
DA95F (WF96) - Printer Parts Removal
5.39 Encoder
Assembly
(continued)
✍
TIP: Make sure you
have the encoder
alignment bushing tool
(PN# WS71001) han-
dy when you remove
the encoder. You will
need this tool if you
wind up replacing the
encoder backing plate.
5-72
5. Loosen set screw by turning the wrench counterclockwise a turn or two
to loosen (do NOT remove the set screw).
6. Unplug ENC harness from encoder.
ENC Harness
7. Using a small screwdriver, separate the main body cover of encoder from
encoder mounting backing at the various "pry points" (see figure below).
Pry
Points
8. Carefully remove the encoder from its backing plate. Try not to damage
the housing or the backing plate if possible because it is placed by the
factory in a precise position.
• If the encoder was removed intact, skip to step 10.
• If the encoder or backing plate does get damaged, you need to re-
place the backing plate as well as the encoder. You also need to have
on hand the special encoder alignment bushing tool (PN#
Continue with step 9.
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
Pry Points
Pry Points
Backing Plate
).
WS71001
<-Two
Screws
Holding
Backing
Plate
(Circled)