Rear Cover And Processor Board - Pitney Bowes DA80F Service Manual

DA95F (WF96) - Printer Parts Removal
5.30 Rear
Cover and Main
Processor
Board
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
WARNING!
Always wear anti static wrist straps (L-8298) whenever handling the Proces-
sor Board or LCD Display Board. Static discharge will damage the IC chips.
1. Turn the power off and unplug the AC power cord.
2. Disengage the feeder assembly from the printer (see section 5.22).
3. Remove printer top cover (see section 5.28).
4. Turn the adjustment knob to loosen the shaft brake. Slide the print head
assemblies away from the front cover.
5. From the feeder side of the printer, unfasten the two screws holding the
rear cover to the entry roller support frame.
Two Screws on
Exit Frame Side
(obscured in
figure)
Rear Cover
Two Screws on
Feeder Side
6. From inside the printer on the exit side, unfasten the two screws holding
the rear cover to the exit frame.
7. Slide the printer to the edge of the table so it completely overhangs the
edge. Unfasten the three screws on the bottom of the rear cover, hanging
onto the cover. IMPORTANT: The figure below is presented to show the
location of the bottom screws only. Do NOT rest the printer on the cover
side that has the hand held because the cover may crack from the weight
of the printer.
Rear Cover
Screws for Rear
Cover (circled)
Removal and Replacement • 5
5-51