DA95F (WF96) - Standard Feeder (WF9S) Parts Removal
5.27 Motor/
Drive
Assembly
on Standard
Feeder
(continued)
DA80F/DA95F AddressRight™ Printers Service Manual (SV61962 Rev. A)
7. Replace in reverse order.
NOTE: When reassembling the shafts, you need to do the adjustments
below.
Gap Adjustment Procedures (if Pulleys have Been Removed from
Shafts)
A. Gap Between Tensioner and Pulley
Place 0.010" shim between tensioner and pulley when reinstalling upper
shaft.
B. Gap Between Pulley and Motor Face
Place 0.150" shim between pulley and motor face when reinstalling the
lower drive shaft.
Removal and Replacement • 5
Pulley
Shim
Tensioner
Motor Face
Pulley
5-47