Display Interface M-Eth0 - H3C S5830V2 Command Reference Manual

Field
Service name
Platform version
Product version
Supported board
[Component]

display interface m-eth0

Use display interface m-eth0 to display information about the management Ethernet port M-Eth 0.
Syntax
display interface m-eth0
Views
Any view
Examples
# Display information about the management Ethernet port.
<boot> display interface m-eth0
m-eth0 current state: UP
Line protocol current state: UP
The Maximum Transmit Unit is 1500
Inet4 Address is 192.168.20.189/24
Inet6 Address is 1:1::1:1/64 Scope:Global
Inet6 Address is FE80::202:3FF:FE04:506/10 Scope:Link
IP Packet Frame Type:PKTFMT_ETHNT_2, Hardware Address: c4ca-d94c-e201
IPV6 Packet Frame Type:PKTFMT_ETHNT_2, Hardware Address: c4ca-d94c-e201
Input: 8983 packets, 0 errors, 0 dropped, 0 overruns, 2 frame
Output: 431 packets, 0 errors, 0 dropped, 0 overruns, 0 carrier,
0 collisions, 1000 txqueuelen
Input bytes:804168
Output bytes:30367
Table 31 Command output
Field
m-eth0 current state
Description
Type of the service package:
boot—Boot image.
•
system—System image.
•
• patch—Patch package.
The value of this field is any other value for feature packages.
Platform version number.
Product version number. You determine whether the version of a system image
matches that of a boot image by checking the value of this field.
Types of cards that the software package supports. The value of mpu indicates the
member device.
Information about the components of the software package.
Description
Physical layer status of the management Ethernet interface:
Administratively DOWN—The interface has been shut
•
down by using the shutdown command.
DOWN—The interface has been enabled by using the
•
undo shutdown command, but its physical status is
down. The interface might not have a cable connected or
206