Telnet Client Source - H3C S5830V2 Command Reference Manual

dscp dscp-value: Specifies the DSCP value for IP to use in outgoing Telnet packets to indicate the
packet transmission priority. The value range is 0 to 63. The default is 48.
Usage guidelines
This command is not supported in FIPS mode.
To terminate the current Telnet connection, press Ctrl+K or execute the quit command.
The source address or interface specified by this command is applied only to the current Telnet
connection.
Examples
# Telnet to host 1.1.1.2, using 1.1.1.1 as the source IP address for outgoing Telnet packets.
<Sysname> telnet 1.1.1.2 source ip 1.1.1.1
Related commands

telnet client source

telnet client source
Use telnet client source to specify a source IPv4 address or source interface for outgoing Telnet
packets when the device acts as a Telnet client.
Use undo telnet client source to remove the configuration.
Syntax
telnet client source { interface interface-type interface-number | ip ip-address }
undo telnet client source
Default
No source IPv4 address or source interface is specified for outgoing Telnet packets. The source IPv4
address is the primary IPv4 address of the outbound interface.
Views
System view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number: Specifies a source interface. The primary IPv4 address of
the interface will be used as the source IPv4 address for outgoing Telnet packets.
ip ip-address: Specifies a source IPv4 address.
Usage guidelines
This command is not supported in FIPS mode.
The source IPv4 address or source interface that is specified by this command applies to all Telnet
connections. However, if a user specifies a source IPv4 address or source interface when executing
the telnet command, the setting specified by the user takes effect.
Examples
# Set the source IPv4 address for outgoing Telnet packets to 1.1.1.1 when the device acts as a Telnet
client.
<Sysname> system-view
[Sysname] telnet client source ip 1.1.1.1
38