Display Qos-Interface All - H3C S3600 Series Command Manual

Command Manual – QoS-QoS Profile
H3C S3600 Series Ethernet Switches-Release 1510
Example
# Display the "COS-to-local-precedence" mapping table.
<H3C> display qos cos-local-precedence-map
cos-local-precedence-map:
------------------------------------------------------------------------
local precedence(queue) :

1.1.3 display qos-interface all

Syntax
display qos-interface { interface-type interface-number | unit-id } all
View
Any view
Parameter
interface-type interface-number: Port index.
unit-id: Unit ID of the switch.
Description
Use the display qos-interface all command to display all the QoS configuration of the
ports. If you do not input port parameters, this command will display the QoS parameter
configuration of all the ports of the switch, including priority remark, queue scheduling,
rate limit, etc; if you input port parameters, this command will display QoS parameter
configuration of the port, including priority remark, queue scheduling, rate limit, etc.
When the IRF feature is enabled, the interface-type interface-number argument or the
unit-id argument must be input.
Example
# Display all the QoS parameter configuration on Ethernet1/0/1.
<H3C> display qos-interface Ethernet 1/0/1 all
Ethernet1/0/1: traffic-limit
Inbound:
Matches: Acl 3001 rule 1
Target rate: 640 kbps
Exceed action: remark-dscp 4
Ethernet1/0/1: traffic-priority
Inbound:
Matches: Acl 2000 rule 0
cos(802.1p) : 0
0
running
running
1-2
Chapter 1 QoS Commands
1 2 3 4
1 2 3 4
5 6 7
5 6 7