Free Line - H3C S5830V2 Command Reference Manual

Usage guidelines
This command is not supported in VTY line view.
The device supports flow control in both the inbound and outbound directions.
•
For flow control in the inbound direction, the local device listens to flow control information from
the remote device.
•
For flow control in the outbound direction, the local device sends flow control information to the
remote device.
The flow control setting takes effect in both directions.
To communicate, two devices must be configured with the same flow control mode.
Examples
# Configure software flow control in the inbound and outbound directions for user line AUX 0.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0] flow-control software

free line

Use free line to release a user line.
Syntax
free line { number1 | { aux | vty } number2 }
Views
User view
Predefined user roles
network-admin
Parameters
number1: Specifies the absolute number of a user line, in the range of 0 to 192.
aux: Specifies the AUX line.
vty: Specifies the VTY line.
number2: Specifies the relative number of a user line. The value range is 0 to 128 for the AUX line
and 0 to 63 for the VTY line.
Usage guidelines
This command does not release the line you are using.
Examples
# Release user line VTY 1:
1. Display online users.
<Sysname> display users
Idx
129
+ 130
Following are more details.
VTY 0
Line Idle
VTY 0 00:10:49
VTY 1 00:00:00
:
Location: 192.168.1.12
Time Pid
Jun 11 11:27:32
Jun 11 11:39:40
24
Type
320 TEL
334 TEL