Polycom SpectraLink 6000 Maintenance And Diagnostics page 41

Component - Alarm -
Second LED First LED
MCU - 1, 2, 4 Test - 1, 2, 4
MCU - 1, 2, 4 TX full - 1, 5
MCU - 1, 2, 4 Read - 1, 2, 5
PC Cfg - 1, 2, No code - 2, 4
3
Router - 1 Test - 1, 2, 4
Router - 1 Program – 3,
4
Router - 1 Download -
1, 3, 5
Router - 1 Error - 1, 2, 3,
4
Router - 1 Start - 1, 3, 4
PN: 1725-36123-001_K.doc
Probable Cause
Code downloaded to the
System Controller was not the
correct code for the hardware.
Internal error.
Internal error.
Configuration not present (will
occur at 1st start up) or flash
memory error
Hardware failure.
Hardware failure.
Hardware failure or wrong
software.
Internal error.
Possibly a bad software
download or Internal error.
Recommendation
Download the correct code.
Contact Polycom Customer Support.
Contact Polycom Customer Support.
If flash alarm is present, replace
System Controller card.
Replace System Controller card.
Replace System Controller card.
If software is suspected, check
supervisor software, otherwise
replace System Controller card.
Contact Polycom Customer Support.
If software is suspected, check
supervisor software; otherwise
contact Polycom Customer Support.
LED and Alarm Troubleshooting Tables
Notes
Config not present error will occur
at first start up but should not
occur in field. Any configuration
stored in the flash will be erased.
May occur in conjunction with flash
errors.
IPC communications will not work
in the system. Keepalive card
alarms can be seen because of
conditions causing this alarm.
IPC Communications will not work
in system. Keepalive card alarms
can be seen because of conditions
causing this alarm.
IPC Communications will not work
in system. Keepalive card alarms
can be seen because of conditions
causing this alarm.
IPC Communications will not work
in system. Keepalive card alarms
can be seen because of conditions
causing this alarm.
41