No Extension/Wrong Extension Displayed; No Svc" Displayed - Polycom SpectraLink 6000 Maintenance And Diagnostics

SpectraLink 6300 MCU: Maintenance and Diagnostics: SpectraLink 6000 System

No Extension/Wrong Extension Displayed

"No Svc" Displayed

18
Transmission obstructions
• Thorough site survey was done prior to installation to determine
the best location for Base Stations for optimum transmission
coverage. However, small pockets of obstruction may still be
present, or obstructions may be introduced into the facility after
system installation. This loss of service can be restored by moving
out of the obstructed area. Base Stations can also be added to
overcome obstructions.
1. Hold down the
FCN
2. Press the key twice until the display reads
#
3. Press , then enter the correct extension number.
0
4. Press when finished.
END
The handset is either not registered, out of range, or can't pick up a
signal from a Base Station.
1. Visually check to see if the handset is within range of a Base
Station where other telephones are working.
2. From the Operator's Console, search for the handset's serial
number or extension number to be sure it is properly registered.
3. If other handsets in the area are also not working, see Chapter 3,
section Multiple Handsets Not Working below.
key until
Volume Level
displays.
Extension.
PN: 1725-36123-001_K.doc