Delete A Base Station - Polycom SpectraLink 6000 Maintenance And Diagnostics

Delete a Base Station

PN: 1725-36123-001_K.doc
Isolated will disable the Listen Verify alarm for that Base Station
and avoid generating spurious alarms.
(optional) type a short description of where the Base Station
Note
was installed (a room or floor number, for example). Up to 30
characters. Do not enter quotes (") in this field or an error message
will display.
6. When information is correctly entered, select
To replace a Base Station, unplug the existing Base Station and plug in
the new Base Station.
• The LED will blink red and green as the system software
downloads to the Base Station and the Base Station is tested.
• When the LED blinks amber, the system is ready for operation.
• When the LED blinks green, a handset has established a radio link
with that Base Station.
• If the LED turns solid red, blinks red, or continues to blink red
and green, refer to Chapter 4 Base Station Problems.
Use this procedure to completely remove a Base Station without
replacing it with a new one.
1. On the Operator's Console, press F4,
.
and Administration
2. Using the arrow keys or mouse, position the cursor on the port
location of the Base Station to be deleted, and press Enter.
3. When the menu displays, scroll down to
Enter.
4. Scroll to and press Enter.
DELETE
5. If you do not intend to move the Base Station to a new location,
disconnect the cabling for this Base Station from the demarc block.
System Maintenance
to save it.
SAVE
Portcard Configuration Display
, and press
Delete RCU
15