Add A Shelf; Delete A Shelf - Polycom SpectraLink 6000 Maintenance And Diagnostics

SpectraLink 6300 MCU: Maintenance and Diagnostics: SpectraLink 6000 System

Add a Shelf

Delete a Shelf

16
If the existing shelves in the MCU are not large enough to hold the
required Interface Modules, you must add a shelf to the system. The
system can support 19 Expansion Shelves.
1. Install the shelf. See SpectraLink 6300 MCU: Installation.
2. If you moved Interface Modules from one shelf into the new shelf,
use the
Move Portcard
Module configuration to reflect the change.
3. Register the new handsets and/or Base Stations on the new shelf.
See Chapter 2, sections Add a Handset and Add A Base Station.
If you move or reconfigure your system, you may need to completely
delete a shelf.
1. On the Operator's Console, press F4,
.
and Administration
2. If you are completely removing the handsets and Base Stations
from this system, delete the Base Stations and handset by deleting
each Interface Module on the shelf using the
(Interface Module) option.
3. If you are moving the handsets and Base Stations from this shelf
to another, use the
designate the new shelf location of the Interface Module. Note that
you cannot move an Interface Module to a slot which already
contains configuration information. Also, the Interface Module
must be physically moved to the new slot and connected with a
cable in order for the module to become operational.
4. When all Interface Modules have been deleted or moved from the
shelf, press F1,
Supervisor State Display
(shelf) option to delete the shelf.
5. After the shelf is deleted from the system you can physically
remove it and its cabling.
function to modify the existing Interface
Portcard Configuration Display
(Interface Module) option to
Move Portcard
. Select the
Delete Portcard
Delete Cabinet
PN: 1725-36123-001_K.doc