Base Station Led Flashing Red; Base Station Led Solid Red Or Yellow - Polycom SpectraLink 6000 Maintenance And Diagnostics

SpectraLink 6300 MCU: Maintenance and Diagnostics: SpectraLink 6000 System

Base Station LED Flashing Red

Base Station LED Solid Red or Yellow

26
4. If the Base Station still does not download, try disconnecting
power from the Base Station and then reconnecting it (unplug the
RJ-45 connector on the Base Station then plug it back in again, or
remove the bridging clips from the demarc block and then replace
them.)
5. On the
Portcard State Display
question and press Enter to show
continuous update of the Base Station's status. The
shows the number of Download Errors. Any number greater than
0 indicates a problem.
These errors are generally caused by hardware problems. Contact
Polycom Customer Support for assistance.
This indicates that the Base Station is not communicating with the
MCU.
1. Follow the instructions in Base Station LED Flashing Red and
Green.
2. Be sure there are no bridge taps ("Y" connections) on the demarc
block. Remove any you find.
3. If the problem persists, follow instructions in Chapter 4, section
Base Station LED Solid Red or Yellow, below.
This indicates a short in the Base Station's transmit or receive wire
pairs, usually within a pair.
Be sure none of the wires are shorted together. Remove the RJ-45
connector from the Base Station. Remove the cable between the
Interface Module and the demarc block. Then use an ohmmeter to be
sure there is an open circuit between pins on the RJ-45. If you do not
want to remove the cabling from the Interface Module (so you do not
interfere with system operation), remove the bridging clips on the
demarc block for that Base Station, then test with the ohmmeter.
(F2) screen, select the Base Station in
Base Station Detail
shows current transmission errors.
RCU Link
PN: 1725-36123-001_K.doc
. This shows
field
DL Errors