Base Station Led Not Lit; Base Station Led Flashing Red And Green - Polycom SpectraLink 6000 Maintenance And Diagnostics

SpectraLink 6300 MCU: Maintenance and Diagnostics: SpectraLink 6000 System

Base Station LED Not Lit

Base Station LED Flashing Red and Green

24
The Base Station is not receiving power. On the
(F2) the status may show
1. Be sure the RJ-45 connector is plugged into the Base Station.
2. Be sure the MCU is turned on.
3. With a voltmeter, check the 48V DC on the wiring between the
MCU and the Base Station.
The LED on the Base Station is designed to flash in specific colors and
patterns to reflect its functioning. At startup the system goes through
a "listen" procedure to ensure that the Base Stations do not interfere
with each other. During the "listen" process the LED will flash red
and green for approximately two minutes.
Certain flashing patterns indicate a problem that needs to be
addressed:
• If the System Controller disables a Base Station because it
interferes with another Base Station, the disabled Base Station's
LED will flash red and green.
If the Base Station is stuck in "download" the LED will flash red
•
and green. In this case, verify the status of the Base Station at the
Operator's Console. Press F2,
, see Chapter 4, section Base Station Disabled, below.
Disabled
• If status is
Download
minutes, see Chapter 4, section Base Station Will Not Download,
below.
Also:
• Try disconnecting and reconnecting the power from the Base
Station. Unplug the RJ-45 connector on the Base Station then plug
it back in again, or remove the bridging clips from the demarc
block and replace them. If necessary, reset several Base Stations at
once by removing the cable from the Interface Module.
Remember, this will also disconnect lines and drop calls!
.
Reset
Portcard State Display
and the DL Time is longer than one to two
screen
Portcard Status
. If status is
PN: 1725-36123-001_K.doc