Add A Handset - Polycom SpectraLink 6000 Maintenance And Diagnostics

SpectraLink 6300 MCU: Maintenance and Diagnostics: SpectraLink 6000 System

Add a Handset

12
Before adding a new handset, you must have a port location on the
demarcation block on the switch and a port location on the
SpectraLink 6300 MCU Interface Module. If no ports are available on
the SpectraLink 6300 MCU, you must install another Interface Module
in the shelf. See SpectraLink 6300 MCU: Installation.
1. Connect the host telephone system port to the SpectraLink 6300
MCU Interface Module port assigned to the new handset.
2. On the Operator's Console, press F4,
.
and Administration
3. Using the arrow keys or mouse, position the cursor on the port
location to be configured, and press Enter.
4. When the menu displays, scroll down to
5. At the pop-up menu, type the information for the handset.
The factory assigned serial number for this
Serial Number
telephone, located inside the battery compartment under the
battery. Double-check this number when it is entered. If the serial
number is entered incorrectly the telephone will not function and
will appear to be defective.
(optional) User name or any other information. Do not enter
Note
quotes (") in this field or an error message will display.
Extension number or SPID. Must be numeric.
Extension/SPID
6. When information is correctly entered, select
7. To program the handset to display the correct extension number,
hold down the
FCN
key until
EXTENSION
the correct extension number. Press
8. When the handset is turned on, the extension will be displayed.
Test the new handsets by placing a call to each one to verify that
the correct telephone rings.
Portcard Configuration Display
key until
Volume Level
displays on the handset. Press
when finished.
END
, and press Enter.
Edit Line
to save it.
SAVE
displays. Press the
# >
, then enter
0
PN: 1725-36123-001_K.doc