Interface Module Status Leds - Polycom SpectraLink 6000 Maintenance And Diagnostics

Interface Module Status LEDs

Interface Module Status LEDs
DISABLE
NORMAL
CONN
B
ALARM
1
2
3
4
5
CONN
A
Interface Module
PN: 1725-36123-001_K.doc
The Status display on the Interface Module consists of: The Status display on the Interface Module consists of:
LED Description
Red/Alarm Always off.
Green 1 Card is up and running.
Green 2 One or more lines in use.
Green 3 One or more Base Stations in use.
Reading the Status LEDs
The LEDs cycle in the following sequence:
1. Status
2. Alarm Code (all LEDs off if no alarm exists)
3. Component (all LEDs off if no alarm exists)
The card will iterate through the list of active alarms showing only
one of the active alarms at a time. A System Controller with two
alarms, for example, would flash the following sequence on the LEDs:
Status - alarm code 1 - alarming component 1 - Status - alarm code 2 -
alarming component 2 - Status - alarm code 1 - alarming component 1
etc.
Troubleshooting Card Alarms
35