Base Station Disabled; Base Station Will Not Download - Polycom SpectraLink 6000 Maintenance And Diagnostics

Base Station Disabled

Base Station Will Not Download

PN: 1725-36123-001_K.doc
• Make sure there are no bridge taps ("Y" connections) on the
demarc blocks. Remove any you find.
• Use a voltmeter to check the lines for the 48 V dc to be sure there
are no power problems.
The System Controller will disable a Base Station if it is too close to
another Base Station or if there are communication errors between the
Base Station and the System Controller. Once disabled the Base
Station does not handle any calls.
1. On the
Portcard State Display
Station is .
Disabled
2. Before moving Base Stations, check the facility's floorplan and the
latest Listen Verify diagnostic (F1,
) for errors and information.
Listen Report
3. To enable this Base Station, disconnect it and relocate it so it is
farther from other Base Stations.
4. Disconnecting and reconnecting the Base Station will
automatically activate the "listen" procedure. Run the Listen
Verify Diagnostic (F1,
sure the problem is corrected without creating any new problems.
If a Base Station is stuck in download, the LED may flash red and
green or just red; the status on the Operator's Console will show
or ; and the Base Station will be locked up (not handling
Download
calls).
1. At the Operator's Console, check to see that the Base Station is
registered, using F2,
2. Check the status of the Base Station. If the status shows
or , the Base Station has locked up during
Download Data
download.
3. To reset the Base Station: From F2,
the Base Station and press Enter, then select
menu.
(F2) check that the status of this Base
Check Listen Verify Report
) and review results to be
Run Listen Verify
.
Portcard State Display
Portcard State Display
Base Station Problems
or
Show
Reset
Download
, highlight
from the
Reset RCU
25