AudioCodes Mediant 800B User Manual page 727

User's Manual
Action Subject
Action Type
Action Value
•
If the source tag name "Type" equals "ITSP" (i.e., SIP message from the ITSP),
then use the value (port number) of the local port on which the incoming message
from the proxy server is received by the device, as the value of the destination
tag name "Port". In other words, the value could either be "6001", "6002", or
"6003". This value is then used by the IP-to-IP Routing table to determine to
which IP PBX to send the message. For example, if the destination tag value is
"6001", the device identifies the destination as "PBX-1":
General
Index
Rule Set ID
Condition
Action
Action Subject
Action Type
Action Value
8. Open the IP-to-IP Routing table (see Configuring SBC IP-to-IP Routing Rules on page
709), and then configure the following IP-to-IP Routing rules:
•
Routes calls from the IP PBXs (identified by the source tag name-value
"Type=PBX") to the ITSP (identified as an IP Group):
General
Index
Name
Match
Source Tag
Action
Destination Type
Destination IP Group
•
Routes calls from the ITSP (identified by the source tag name-value
"Type=ITSP") to the IP PBXs (identified by the specific port assigned to the IP
PBX by the value of the destination tag name "Port"):
General
Index
Name
Match
Version 7.2
message.outgoing.local-port
Modify
param.ipg.src.tags.Port
3
1
srctags.Type=='ITSP'
dsttags.Port
Modify
message.incoming.local-port
1
PBX-to-ITSP
Type=PBX
IP Group
ITSP
2
ITSP-to-PBX
727 Mediant 800B Gateway & E-SBC
34. Routing SBC