Debugging And Diagnostics Parameters; General Parameters - AudioCodes Mediant 800B User Manual

Parameter
End Time / Day of Month
End
configure system > clock >
summer-time > end
[DayLightSavingTimeEnd]
Offset
configure system > clock >
summer-time > offset
[DayLightSavingTimeOffset]
72.3

Debugging and Diagnostics Parameters

This subsection describes the device's debugging and diagnostic parameters.

72.3.1 General Parameters

The general debugging and diagnostic parameters are described in the table below.
Table 72-18: General Debugging and Diagnostic Parameters
Parameter
[EnableDiagnostics]
User's Manual

wk denotes week of the month (e.g., 03)

hh denotes hour (e.g., 23)

mm denotes minutes (e.g., 10)
For example, "04:FRI/03:23:00" denotes Friday, the third week of
April, at 11 P.M. The week field can be 1-5, where 5 denotes the
last occurrence of the specified day in the specified month. For
example, "04:FRI/05:23:00" denotes the last Friday of April, at 11
P.M.
Defines the date and time when DST ends. For a description of the
format of this value, see the DayLightSavingTimeStart parameter.
Defines the DST offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For example, if
you configure the parameter at 15:42, the device applies the setting
only at 16:00.
Determines the method for verifying correct functioning of the
different hardware components on the device. On completion of the
check and if the test fails, the device sends information on the test
results of each hardware component to the Syslog server.

[0] = (Default) Rapid and Enhanced self-test mode.

[1] = Detailed self-test mode (full test of DSPs, PCM, Switch, LAN,
PHY and Flash).

[2] = A quicker version of the Detailed self-test mode (full test of
DSPs, PCM, Switch, LAN, PHY, but partial test of Flash).
Note: For the parameter to take effect, a device reset is required.
1082
Mediant 800B Gateway & E-SBC
Description
Description
Document #: LTRT-10632