Multilevel Precedence And Preemption - AudioCodes Mediant 800B User Manual

Note:
•
The device also identifies emergency calls if the Priority header of the incoming
SIP INVITE message contains the "emergency" value.
•
This feature is applicable to the following interfaces:
√
FXO
√
ISDN
√
CAS
•
For Trunk Groups configured with call preemption, all must be configured to MLPP
[1] or all configured to Emergency [2]. In other words, you cannot set some trunks
to [1] and some to [2].
•
The global parameter must be set to the same value as that of the Tel Profile
parameter; otherwise, the Tel Profile parameter is not applied.
•
If you configure call preemption using the global parameter and a new Tel Profile
is subsequently added, the TelProfile_CallPriorityMode parameter automatically
acquires the same setting as well.
•
For FXO interfaces, the preemption is done only on existing IP-to-Tel calls. In
other words, if all the current FXO channels are busy with calls that were
answered by the FXO device (i.e., Tel-to-IP calls), new incoming emergency IP-to-
Tel calls are rejected.

27.12 Multilevel Precedence and Preemption

The device supports Multilevel Precedence and Preemption (MLPP) service. MLPP is a
call priority scheme, which does the following:

Assigns a precedence level (priority level) to specific phone calls or messages.

Allows higher priority calls (precedence call) and messages to preempt lower priority
calls and messages (i.e., terminates existing lower priority calls) that are recognized
within a user-defined domain (MLPP domain ID). The domain specifies the collection
of devices and resources that are associated with an MLPP subscriber. When an
MLPP subscriber that belongs to a particular domain places a precedence call to
another MLPP subscriber that belongs to the same domain, MLPP service can
preempt the existing call that the called MLPP subscriber is on for a higher-
precedence call. MLPP service availability does not apply across different domains.
MLPP is typically used in the military where, for example, high-ranking personnel can
preempt active calls during network stress scenarios such as a national emergency or
degraded network situations.
MLPP can be enabled for all calls, using the global parameter, CallPriorityMode, or for
specific calls using the Tel Profile parameter, CallPriorityMode.
User's Manual
Mediant 800B Gateway & E-SBC
614 Document #: LTRT-10632