Configuring Sip Recording Rules - AudioCodes Mediant 800B User Manual

2. From the 'SIP Recording Application' drop-down list, select Enable.
3. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
Note: SIPRec is a license-dependant feature and is available only if it is included in
the License Key installed on the device. For more information, see SIP-based Media
Recording on page 237.

15.2.2 Configuring SIP Recording Rules

The SIP Recording Rules table lets you configure up to 30 SIP-based media recording
rules. A SIP Recording rule defines call routes that you want to record. For an overview of
the feature, see 'SIP-based Media Recording' on page 237.
Note: To view the total number of currently active SIPRec signaling sessions, use the
CLI command show voip calls statistics siprec. For more information, refer to the
CLI Reference Guide.
The following procedure describes how to configure SIP Recording rules through the Web
interface. You can also configure it through ini file (SIPRecRouting) or CLI (configure voip >
sip-definition sip-recording sip-rec-routing).

To configure a SIP Recording Routing rule:
1. Open the SIP Recording Rules table (Setup menu > Signaling & Media tab > SIP
Recording folder > SIP Recording Rules).
2. Click New; the following dialog box appears:
The figure above shows a configuration example where the device records calls made
by IP Group "ITSP" to IP Group "IP-PBX" that have the destination number prefix
"1800". The device records the calls from the leg interfacing with IP Group "IP PBX"
(peer) and sends the recorded media to IP Group "SRS-1". SRS redundancy has also
been configured, where IP Group "SRS-1" is the active SRS and IP Group "SRS-2"
the standby SRS.
3. Configure a SIP recording rule according to the parameters described in the table
below.
User's Manual
Mediant 800B Gateway & E-SBC
242 Document #: LTRT-10632