Rejecting Anonymous Calls - AudioCodes Mediant 800B User Manual


To enable call waiting per port:
1. Open the Call Waiting table (Setup menu > Signaling & Media tab > Gateway folder
> Analog Gateway > Call Waiting).
2. Select the row corresponding to the port that you want to configure, and then click
Edit; the following dialog box appears:
3. Configure call waiting per port according to the parameters described in the table
below.
4. Click Apply.
Table 28-6: Call Waiting Table Parameter Descriptions
Parameter
General
Index
[CallWaitingPerPort_Index]
Module
[CallWaitingPerPort_Module]
Port
[CallWaitingPerPort_Port]
Port Type
[CallWaitingPerPort_PortType]
Caller Waiting
Enable Call Waiting
enable-call-waiting
[CallWaitingPerPort_IsEnabled]

28.10 Rejecting Anonymous Calls

The device can reject anonymous calls received from the IP and destined to an FXS port.
To configure the functionality, use the ini file parameter, RejectAnonymousCallPerPort. If
configured for a specific port and the port receives an anonymous call, the device rejects
the call and responds with a SIP 433 (Anonymity Disallowed) response. For a description
of the parameter see 'Caller ID Parameters' on page 1187.
User's Manual
Figure 28-8: Call Waiting Table - Edit Dialog Box
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
(Read-only) Displays the module number on which the port is
located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (e.g., FXS).
Enables call waiting for the port.

[0] Disable

[1] Enable
642
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10632