AudioCodes Mediant 800B User Manual page 1038

Parameter
Destination Transport Type
dst-transport
[Test_Call_DestTransportType]
QoE Profile
qoe-profile
[Test_Call_QOEProfile]
Bandwidth Profile
bandwidth-profile
[Test_Call_BWProfile]
Authentication
Note: These parameters are applicable only if the 'Call Party' parameter (see below) is configured to
Caller.
Auto Register
auto-register
[Test_Call_AutoRegister]
Username
user-name
[Test_Call_UserName]
Password
password
[Test_Call_Password]
Test Setting
Call Party
call-party
[Test_Call_CallParty]
Maximum Channels for
Session
max-channels
[Test_Call_MaxChannels]
User's Manual
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: The parameter is applicable only if the 'Route By' parameter
is set to Dest Address.
Assigns a QoE Profile to the test call.
By default, no value is defined.
To configure QoE Profiles, see 'Configuring Quality of Experience
Profiles' on page 327.
Assigns a Bandwidth Profile to the test call.
By default, no value is defined.
To configure Bandwidth Profiles, see 'Configuring Bandwidth
Profiles' on page 332.
Enables automatic registration of the endpoint. The endpoint can
register to the device itself or to the 'Destination Address' or 'IP
Group' parameter settings (see above).

[0] Disable (default)

[1] Enable
Defines the authentication username.
By default, no username is defined.
Defines the authentication password.
By default, no password is defined.
Defines whether the test endpoint is the initiator (caller) or receiving
side (called) of the test call.

[0] Caller (default)

[1] Called
Defines the maximum number of concurrent channels for the test
session. For example, if you have configured an endpoint "101" and
you configure the parameter to "3", the device automatically creates
three simulated endpoints - "101", "102" and "103" (i.e., consecutive
endpoint URIs are assigned).
The default is 1.
1038
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10632