AudioCodes Mediant 800B User Manual page 557

User's Manual
The following procedure describes how to configure number manipulation rules through the
Web interface. You can also configure this using the following management tools:

Destination Phone Number Manipulation for IP-to-Tel Calls table: ini file
(NumberMapIP2Tel) or CLI (configure voip > gateway manipulation dst-number-map-
ip2tel)

Destination Phone Number Manipulation for Tel-to-IP Calls table: ini file
(NumberMapTel2IP) or CLI (configure voip > gateway manipulation dst-number-map-
tel2ip)

Source Phone Number Manipulation for IP-to-Tel Calls table: ini file
(SourceNumberMapIP2Tel) or CLI (configure voip > gateway manipulation src-
number-map-ip2tel)

Source Phone Number Manipulation for Tel-to-IP Calls table: ini file
(SourceNumberMapTel2IP) or CLI (configure voip > gateway manipulation src-
number-map-tel2ip)

To configure a number manipulation rule:
1. Open the required Phone Number Manipulation table (Setup menu > Signaling &
Media tab > Gateway folder > Manipulation > Dest Number IP->Tel, Dest Number
Tel->IP, Source Number IP->Tel, or Source Number Tel->IP).
2. Click New; the following dialog box appears:
Figure 25-2: Phone Number Manipulation Table (Example) - Add Dialog Box
3. Configure a number manipulation rule according to the parameters described in the
table below.
4. Click Apply.
The table below shows configuration examples of Tel-to-IP source phone number
manipulation rules configured in the Source Phone Number Manipulation for Tel-to-IP Calls
table:
Table 25-1: Configuration Examples of Source Phone Number Manipulation for Tel-to-IP Calls
Parameter
Destination
Prefix
Source Prefix
Version 7.2
Rule 1 Rule 2
03
201 1001
Rule 3
*
123451001#
557 Mediant 800B Gateway & E-SBC
25. Manipulation
Rule 4 Rule 5
* [6,7,8]
[30-40]x 2001