Obtaining Ip Destination From Dial Plan File; Modifying Isdn-To-Ip Calling Party Number - AudioCodes Mediant 800B User Manual

User's Manual

47.6.4 Obtaining IP Destination from Dial Plan File

You can use a Dial Plan index listed in a loaded Dial Plan file for determining the IP
destination of Tel-to-IP and SBC (see note below) calls. This enables the mapping of called
numbers to IP addresses (in dotted-decimal notation) or FQDNs (up to 15 characters).
Note:
IP address using the Dial Plan file is for backward compatibility purposes only. For the
new method, see Configuring Dial Plans on page 751.

To configure routing to an IP destination based on Dial Plan:
1. Create the Dial Plan file. The syntax of the Dial Plan index for this feature is as
follows:
<destination / called prefix number>,0,<IP destination>
Note: The second parameter "0" is not used and ignored.
An example of a configured Dial Plan (# 6) in the Dial Plan file is shown below:
[ PLAN6 ]
200,0,10.33.8.52
10.33.8.52
201,0,10.33.8.52
300,0,itsp.com
2. Convert the file to a loadable file and then load it to the device (see 'Creating a Dial
Plan File' on page 839).
3. Assign the Dial Plan index to the required routing rule:
•
SBC Calls: In the SBC IP-to-IP Routing table, do the following:
a.
b.
•
Tel-to-IP Calls (Gateway application): In the Tel-to-IP Routing table, do the
following:
a.
Note:

47.6.5 Modifying ISDN-to-IP Calling Party Number

You can use the Dial Plan file to change the Calling Party Number value (source number)
of the incoming ISDN call when sending to IP.
Version 7.2
For the SBC application, the method described in this section for obtaining an
; called prefix 200 is routed to
; called prefix 300 is routed to itsp.com
Set the 'Destination Type' field to Dial Plan.
In the 'Destination Address' field, enter the required Dial Plan index, where
"0" denotes [PLAN1] in the Dial Plan file, "1" denotes [PLAN2], and so on.
In the 'Destination Address' field, enter the required Dial Plan index using the
following syntax:
DialPlan<index>
Where "DialPlan0" denotes [PLAN1] in the Dial Plan file, "DialPlan1" denotes
[PLAN2], and so on.
The "DialPlan" string is case-sensitive.
845 Mediant 800B Gateway & E-SBC
47. Auxiliary Files