AudioCodes Mediant 800B User Manual page 287

User's Manual
Note:
•
You cannot configure overlapping Time Bands.
•
If a Time Band is not configured for a specific day and time range, the default
connection cost and default minute cost configured for the Cost Group in the Cost
Groups table is applied.
The following procedure describes how to configure Time Bands per Cost Group through the
Web interface. You can also configure it through ini file (CostGroupTimebands) or CLI (configure
voip > sip-definition least-cost-routing cost-group-time-bands).

To configure a Time Band per Cost Group:
1. Open the Cost Groups table (Setup menu > Signaling & Media tab > SIP Definitions folder
> Least Cost Routing > Cost Groups).
2. Select a Cost Group for which you want to assign Time Bands, and then click the Time
Band link located below the table; the Time Band table for the selected Cost Group appears.
3. Click New; the following dialog box appears:
4. Configure a Time Band according to the parameters described in the table below.
5. Click Apply, and then save your settings to flash memory.
Parameter
Index
timeband-index
[CostGroupTimebands_TimebandIndex]
Start Time
start-time
[CostGroupTimebands_StartTime]
Version 7.2
Table 15-18: Time Band Table Description
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the day and time of day from when this time band is
applicable. The format is DDD:hh:mm, where:

DDD is the day of the week, represented by the first three
letters of the day in upper case (i.e., SUN, MON, TUE, WED,
THU, FRI, or SAT).

hh and mm denote the time of day, where hh is the hour (00-
23) and mm the minutes (00-59)
For example, SAT:22:00 denotes Saturday at 10 pm.
287
Description
Mediant 800B Gateway & E-SBC
15. Services