AudioCodes Mediant 800B User Manual page 362

Parameter
Pre Classification
Manipulation Set ID
preclassification-manset
[SIPInterface_PreClassificati
onManipulationSet]
Media
Media Realm
media-realm-name
[SIPInterface_MediaRealm]
Direct Media
sbc-direct-media
[SIPInterface_SBCDirectMe
dia]
User's Manual
response. Once the scanner finds a device that supports SIP, it
extracts information from the response and identifies the type of
device (IP address and name) and can execute DoS attacks. A way to
defend the device against such attacks is to not send a SIP reject
response to these unclassified "calls" so that the attacker assumes
that no device exists at such an IP address and port.
Note:

The parameter is applicable only if you configure the device to
reject unclassified calls, which is done using the 'Unclassified Calls'
parameter (see Configuring Classification Rules on page 701).

The parameter is applicable only to the SBC application.
Assigns a Message Manipulation Set ID to the SIP Interface. This lets
you apply SIP message manipulation rules on incoming SIP initiating-
dialog request messages (not in-dialog), received on this SIP
Interface, prior to the Classification process.
By default, no Message Manipulation Set ID is defined.
To configure Message Manipulation rules, see Configuring SIP
Message Manipulation on page 413.
Note:

The Message Manipulation Set assigned to a SIP Interface that is
associated with an outgoing call, is ignored. Only the Message
Manipulation Set assigned to the associated IP Group is applied to
the outgoing call.

If both the SIP Interface and IP Group associated with the incoming
call are assigned a Message Manipulation Set, the one assigned to
the SIP Interface is applied first.

The parameter is applicable only to the SBC application.
Assigns a Media Realm to the SIP Interface.
By default, no value is defined.
To configure Media Realms, see 'Configuring Media Realms' on page
339.
Enables direct media (RTP/SRTP) flow (i.e., no Media Anchoring)
between endpoints associated with the SIP Interface.

[0] Disable = (Default) Media Anchoring is employed, whereby the
media stream traverses the device (and each leg uses a different
coder or coder parameters).

[1] Enable = No Media Anchoring. Media stream flows directly
between endpoints (i.e., does not traverse the device - no Media
Anchoring).

[2] Enable when Same NAT = No Media Anchoring. Media stream
flows directly between endpoints if they are located behind the
same NAT.
Note:

If the parameter is enabled for direct media and the two endpoints
belong to the same SIP Interface, calls cannot be established if the
following scenario exists:
a. One of the endpoints is defined as a foreign user (for example,
"follow me service")
b. and one endpoint is located on the WAN and the other on the
362
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10632