AudioCodes Mediant 800B User Manual page 396

3. Configure an account according to the parameters described in the table below.
4. Click Apply.
Once you have configured Accounts, you can register or un-register them, as described
below:

To register or un-register an Account:
1. In the table, select the required Account entry row.
2. From the Action drop-down list, choose one of the following commands:
•
Register to register the Account.
•
Un-Register to un-register the Account.
To view Account registration status, see 'Viewing Registration Status' on page 949.
If all trunks belonging to the Trunk Group are down, the device un-registers them. If any
trunk belonging to the Trunk Group is returned to service, the device registers them again.
This ensures, for example, that the Proxy does not send INVITEs to trunks that are out of
service.
If registration with an IP Group fails for all accounts of a specific Trunk Group that includes
all the channels in the Trunk Group, the Trunk Group is set to Out-Of-Service if the
OOSOnRegistrationFail parameter is set to 1 (see Proxy & Registration Parameters on
page 402).
Parameter
Served Trunk Group
served-trunk-group
[Account_ServedTrunkGroup]
General
Index
User's Manual
Table 18-1: Accounts Table Parameter Descriptions
Defines the Trunk Group ID that you want to register
and/or authenticate.


Note: The parameter is applicable only to the Gateway
application.
Defines an index for the new table row.
Note: Each row must be configured with a unique index.
Mediant 800B Gateway & E-SBC
Description
For Tel-to-IP calls, the served Trunk Group is the
source Trunk Group from where the call originated.
For IP-to-Tel calls, the served Trunk Group is the
Trunk Group ID to where the call is sent.
396 Document #: LTRT-10632