AudioCodes Mediant 800B User Manual page 1039

Gateway & enterprise sbc (e-sbc)
Hide thumbs Also See for Mediant 800B:
Table of Contents

Advertisement

User's Manual
Parameter
Call Duration
call-duration
[Test_Call_CallDuration]
Calls per Second
calls-per-second
[Test_Call_CallsPerSecond]
Test Mode
test-mode
[Test_Call_TestMode]
Test Duration
test-duration
[Test_Call_TestDuration]
Play
play
[Test_Call_Play]
Version 7.2
Defines the call duration (in seconds).
The valid value is -1 to 100000. The default is 20. A value of 0
means infinite. A value of -1 means that the parameter value is
automatically calculated according to the values of the 'Calls per
Second' and 'Maximum Channels for Session' parameters.
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Defines the number of calls per second.
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Defines the test session mode.
[0] Once = (Default) The test runs until the lowest value between
the following is reached:
Maximum channels is reached for the test session,
configured by 'Maximum Channels for Session'.
Call duration ('Call Duration') multiplied by calls per second
('Calls per Second').
Test duration expires, configured by 'Test Duration'.
[1] Continuous = The test runs until the configured test duration
is reached. If it reaches the maximum channels configured for
the test session (in the 'Maximum Channels for Session'), it waits
until the configured call duration of a currently established tested
call expires before making the next test call. In this way, the test
session stays within the configured maximum channels.
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Defines the test duration (in minutes).
The valid value is 0 to 100000. The default is 0 (i.e., unlimited).
Note: The parameter is applicable only if you configure 'Call Party'
to Caller.
Enables and defines the playing of a tone to the answered side of
the call.
[0] Disable
[1] DTMF = (Default) Plays a user-defined DTMF string,
configured in 'Configuring DTMF Tones for Test Calls' on page
1042.
[2] PRT = Plays a non-DTMF tone from the PRT file (Test Call
Tone). For this option, you must load a PRT file to the device
(see 'Prerecorded Tones File' on page 838).
Note:
To configure the DTMF signaling type (e.g., out-of-band or in-
band) use the 'DTMF Transport Type' parameter (see
'Configuring DTMF Transport Types' on page 208).
The parameter is applicable only if you configure 'Call Party' to
Caller.
1039
69. Testing SIP Signaling Calls
Description
Mediant 800B Gateway & E-SBC

Advertisement

Table of Contents
loading

Table of Contents