AudioCodes Mediant 800B User Manual page 291

User's Manual
Parameter
Policy
http-policy
[HTTPRemoteServices_Policy]
Persistent Connection
http-persistent-
connection
[HTTPRemoteServices_Persist
entConnection]
Number of Sockets
http-num-sockets
[HTTPRemoteServices_NumOf
Sockets]
Login
Login Needed
http-login-needed
[HTTPRemoteServices_LoginN
eeded]
Username
rest-user-name
[HTTPRemoteServices_AuthUs
erName]
Password
rest-password
[HTTPRemoteServices_AuthPa
ssword]
Security
TLS Context
rest-tls-context
[HTTPRemoteServices_TLSCo
ntext]
Version 7.2
Defines the mode of operation when you have configured multiple remote
hosts (in the HTTP Remote Hosts table) for a specific remote Web
service.

[0] Round Robin = (Default) Load balancing of traffic across all
configured hosts. Every consecutive message is sent to the next
available host.

[1] Sticky Primary = Device always attempts to send traffic to the first
(primary) host. If the host does not respond, the device sends the
traffic to the next available host. If the primary host becomes available
again, the device sends the traffic to the primary host.

[2] Sticky Next = Similar to Sticky Primary, but if the primary host
does not respond, the device sends the traffic to the next available
host and continues sending traffic to this host even if the primary host
becomes available again.
Defines whether the HTTP connection with the host remains open or is
only opened per request.

[0] Disable = Connection is not persistent and closes when the device
detects inactivity. The device uses HTTP keep-alive messages to
detect inactivity.

[1] Enable = (Default) Connection remains open (persistent) even
during inactivity. The device uses HTTP keep-alive / HTTP persistent
connection messages to keep the connection open.
Defines how many sockets (connection) are established per remote host.
The valid value is 1 to 10. The default is 1.
Enables the use of proprietary REST API Login and Logout commands
for connecting to the remote host. The commands verify specific
information (e.g., software version) before allowing connectivity with the
device.

[0] Disable = Commands are not used.

[1] Enable (default)
Defines the username for HTTP authentication.
The valid value is a string of up to 80 characters. The default is "user".
Defines the password for HTTP authentication.
The valid value is a string of up to 80 characters. The default is
"password".
Assigns a TLS Context for connection with the remote host.
By default, no value is defined.
To configure TLS Contexts, see 'Configuring TLS Certificate Contexts' on
page 113.
Note: The parameter is applicable only if the connection is HTTPS.
291
Description
Mediant 800B Gateway & E-SBC
15. Services