Configuring Redirect Number Ip To Tel - AudioCodes Mediant 800B User Manual

Parameter
Right
remove-from-right
[_RemoveFromRight]
Number of Characters to
Leave
num-of-digits-to-leave
[LeaveFromRight]
Prefix to Add
prefix-to-add
[_Prefix2Add]
Suffix to Add
suffix-to-add
[_Suffix2Add]
25.5

Configuring Redirect Number IP to Tel

The redirect number manipulation tables let you configure rules for manipulating the
redirect number received in SIP messages. The redirect number manipulation tables
include:

Redirect Number IP-to-Tel table: (Applicable only ISDN) Defines IP-to-Tel redirect
number manipulation. You can manipulate the value of the received SIP Diversion,
Resource-Priority, or History-Info headers, which is then added to the Redirecting
Number Information Element (IE) in the ISDN Setup message sent to the Tel side.
This also includes the reason for the call redirection.

Redirect Number Tel to IP table: Defines Tel-to-IP redirect number manipulation. You
can manipulate the prefix of the redirect number received from the Tel side, in the
outgoing SIP Diversion, Resource-Priority, or History-Info headers sent to the IP side.
Configuration of redirect number manipulation rules includes two areas:

Match: Defines the matching characteristics of an incoming call (e.g., prefix of redirect
number).

Action: Defines the action that is done if the incoming call matches the characteristics
of the rule (e.g., removes a user-defined number of digits from the left of the redirect
number).
The device searches the table from top to bottom for the first rule that matches the
characteristics of the incoming call. If it finds a matching rule, it applies the manipulation
configured for that rule.
Note:
•
If the device copies the received destination number to the outgoing SIP redirect
number (enabled by the CopyDest2RedirectNumber parameter), no redirect
number Tel-to-IP manipulation is done.
•
The manipulation rules are done in the following order: 'Stripped Digits From Left',
'Stripped Digits From Right', 'Number of Digits to Leave', 'Prefix to Add', and then
'Suffix to Add'.
•
The device uses the 'Redirect Prefix' parameter before it manipulates the prefix.
User's Manual
name.
For example, if you enter 3 and the calling name is "company:name",
the new name is "company:n".
Defines the number of characters that you want to keep from the right
of the calling name.
For example, if you enter 4 and the calling name is "company:name",
the new name is "name".
Defines the number or string to add at the front of the calling name.
For example, if you enter ITSP and the calling name is
"company:name", the new name is ITSPcompany:john".
Defines the number or string to add at the end of the calling name.
For example, if you enter 00 and calling name is "company:name", the
new name is "company:name00".
566
Mediant 800B Gateway & E-SBC
Description
Document #: LTRT-10632