AudioCodes Mediant 500L User Manual page 55

User's Manual
device reset for your changes to take effect. When you change such a parameter and
then click Apply, the Reset button on the toolbar is encircled by a red border. If you
click the button, the Maintenance Actions page opens, which provides commands for
doing this (see ''Basic Maintenance'' on page 779).

Typically required parameters are displayed in bold font.

If you enter an invalid value for a parameter and then click Apply, a message box
appears notifying you of the invalid value. Click OK to close the message. The
parameter reverts to its previous value and the field is surrounded by a colored border,
as shown in the figure below:

To get help on a parameter, simply hover your mouse over the parameter's field and a
pop-up help appears, displaying a brief description of the parameter.
The following procedure describes how to configure stand-alone parameters.

To configure a stand-alone parameter:
1. Modify the parameter's value as desired.
2. Click Apply; the changes are saved to the device's volatile memory (RAM).
3. Save the changes to the device's non-volatile memory (flash):
•
If a device reset is not required:
a.
b.
•
If a device reset is required:
a.
b.
Warning:
memory and thus, revert to their previous settings if the device later undergoes a
hardware reset, a software reset (without saving to flash) or powers down. Therefore,
make sure that you save your configuration to the device's flash memory.
Version 7.2
On the toolbar, click Save; a confirmation message box appears:
Figure 6-4: Save Configuration Confirmation Box
Click Yes to confirm; the changes are save to flash memory.
On the toolbar, click Reset; the Maintenance Actions page opens.
Click Reset; the device saves the changes to flash memory and then resets.
When you click Apply, your changes are saved only to the device's volatile
55 Mediant 500L Gateway & E-SBC
6. Web-Based Management