Download  Print this page

Honeywell Hyperion 1300g Quick Start Manual

Linear scanner
Hide thumbs


Hyperion 1300g
Linear Scanner

Quick Start Guide

Aller à
Vai a
Gehe zu
Ir a
Para Português, acesse
Перейти на русскоязычный сайт
日本語 :
如要到中国简体) 。
pour le français.
per l'italiano.
für Deutsch.
para español.
로 이동합니다 .
HP1300-QS Rev A



  Also See for Honeywell Hyperion 1300g

  Related Manuals for Honeywell Hyperion 1300g

  Summary of Contents for Honeywell Hyperion 1300g

  • Page 1: Quick Start Guide

    Hyperion 1300g Linear Scanner Quick Start Guide Aller à pour le français. Vai a per l'italiano. Gehe zu für Deutsch. Ir a para español. Para Português, acesse Перейти на русскоязычный сайт 日本語 : をご覧ください。...
  • Page 2: Getting Started

    Note: Refer to your user’s guide for information about cleaning your device. Getting Started Turn off the computer’s power before connecting the scanner, then power up the computer once the scanner is fully connected. Power Supply Assembly (if included) Connecting the Scanner USB:...
  • Page 3 Serial (RS232): RS485: Keyboard Wedge:...
  • Page 4: Reading Techniques

    Reading Techniques Standard Product Defaults The following bar code resets all standard product default settings. Standard Product Defaults RS485 Interface The RS485 interface defaults to port 5B. If you have an IBM POS terminal using port 9B, scan the appropriate code below to program the terminal, then power cycle the cash register.
  • Page 5: Keyboard Country

    Keyboard Country Scan the Program Keyboard Country bar code below, then scan the numeric bar code(s) from the end of this document, then the Save bar code to program the keyboard for your country. As a general rule, the following characters are not supported by the scanner for countries other than the United States: @ | $ # { } [ ] = / ‘...
  • Page 6: Reread Delay

    Trigger The following bar codes will allow you to use the reader in Manual Trigger mode (need to press the trigger to read), Automatic Trigger mode (the beam is always on), or Presentation mode (the reader is activated when it “sees” a bar code). Manual Trigger (Default) Automatic Trigger...
  • Page 7: Suffix

    Suffix If you want a carriage return after the bar code, scan the Add CR Suffix bar code. To add a tab after the bar code, scan the Add Tab Suffix bar code. Otherwise, scan the Remove Suffix bar code to remove the suffixes.
  • Page 8: Data Format Editor Instructions

    Data Format Editor Instructions The following are abbreviated instructions for entering a data format. For complete instructions refer to your User’s Guide, available at our website, 1. Scan the Enter Data Format symbol. 2. Primary/Alternate Format: scan 0 for Primary Format 3.
  • Page 9: Programming Chart

    Programming Chart...
  • Page 10 Save...
  • Page 11: Technical Assistance

    For localized versions of this document, and to download the User’s Guide, go to Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.

This manual is also suitable for:

Voyager 1200g