Table of Contents
Advertisement
specified via the Remote UI. This section also describes the procedure to configure settings for communication
between the machine and plug-ins for iW Management Console.
*
For more information about iW Management Console, contact your local authorized Canon dealer.
To use iW Management Console plug-ins
●
You need to enable the settings of the dedicated port and the SNMP settings. As for the SNMP settings, set
[MIB Access Permission] to [Read/Write] for both SNMPv1 and SNMPv3.
<Use Dedicated Port>(P. 470)
Monitoring and Controlling the Machine with SNMP(P. 67)
Remote UI Operations
●
For more information about the basic operations to be performed when setting the machine from the
Remote UI, see
Setting Up Menu Options from Remote UI(P. 434) .
◼
Configuring SLP Communication with Device Management Software
1
Start the Remote UI and log in to System Manager Mode.
UI(P. 427)
2
Click [Settings/Registration] on the Portal page.
3
Click [Network Settings].
4
Specify SLP settings.
Specifying multicast device discovery
1
Select [Multicast Discovery Settings]
2
Select the [Respond to Discovery] check box and specify the required settings.
[Respond to Discovery]
Select the check box to set the machine to respond to device management software multicast discovery
packets and enable monitoring by device management software.
Setting Up
Remote UI Screen(P. 428)
[Edit].
73
Starting Remote
Advertisement
Table of Contents
