Table of Contents
Advertisement
●
Divide the document into multiple sections before sending.
●
Delete the documents that are stored in memory.
●
Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
#751
The FTP server has not been started up or a network connection has been cut.
(Failure to connect to the destination is sometimes caused by a disconnection en route.)
●
Check the destination.
●
Check the network status.
Viewing Network Settings(P. 36)
The IP address was not set correctly.
●
Check <TCP/IP Settings>.
Setting IP Addresses(P. 29)
#752
E-mail sending or I-Fax sending/receiving was impossible because an incorrect SMTP/POP3 server name
was set.
●
Check the SMTP/POP3 server name, and correct the setting.
Specifying E-Mail Settings(P. 319)
Configuring E-Mail/I-Fax Communication Settings(P. 85)
E-mail sending or I-Fax sending/receiving was impossible because an incorrect domain name was set.
●
Check the domain name, and correct the setting.
Configuring DNS(P. 54)
E-mail sending or I-Fax sending/receiving was impossible because the machine was not connected to a
network correctly.
●
Check whether the machine is properly installed and correctly connected to the network.
Settings Problems(P. 638)
#753
Scanned data could not be sent as e-mail, not sent/received as I-Fax, or not stored in the shared
folder/FTP server because the LAN cable is disconnected.
●
Check whether the LAN cable is connected correctly.
Connecting to a Wired LAN(P. 15)
#755
Scanned data could not be sent as e-mail or I-Fax nor stored in the shared folder or FTP server because
TCP/IP was not working correctly.
●
Check <TCP/IP Settings>, and set correctly.
Troubleshooting
671
Advertisement
Table of Contents
