Table of Contents
Advertisement
●
Even when ECM is enabled, errors may occur due to telephone line conditions.
●
It may take a longer time than usual to process data when ECM is enabled because the error checks
and corrections are performed while the data is transmitted.
*2
<Set Pause Time>
For example, when you make calls by dialing "0 - (pause) - (telephone number)," 0 is dialed first and then a few
seconds later, the telephone number. When sending faxes overseas, you need to specify destinations by dialing
"(international access code) - (country code) - (area code) - (fax number)" but consecutive numbers that are
input without pauses may not be recognized correctly. In this case, try adding a pause after the international
access code or the fax number. If the code or the number is still not recognized correctly, change the duration
of the pause. For instructions on how to enter a pause, see step 4 on
Faxes(P. 221) .
1 to 4
to 15 (sec.)
<Menu>
<Function Settings>
duration of pause
*2
<Auto Redial>
Specify settings for Auto Redial, a function that automatically redials the fax number after several minutes if the
first attempt fails because the line is busy. You can specify how many times the machine redials and the interval
between redials.
<Use Auto Redial>
<Off>
<On>
<Number of Times to Redial>
1 to 2
to 10 (time(s))
<Redial Interval>
2
to 99 (min.)
<Redial When Error Occurs>
<Off>
<On>
<Menu>
<Function Settings>
Auto Redial>
<Number of Times to Redial>
Specifies how many times the machine redials. Enter a number, and select <Apply>.
Setting Menu List
<Send>
<Apply>
<Send>
Specify the settings
<Apply>
547
Basic Operations for Sending
<Fax Settings>
<Set Pause Time>
<Fax Settings>
<Auto Redial>
Specify the
Select <On> in <Use
Advertisement
Table of Contents
