1.2 One-Touch Configuration
NVR Configuration Guide (Advanced) for NRS Expanded Series
2. Check the Enable RAID checkbox.
3. Click Apply to save the settings.
Through one-touch configuration, you can quickly create the disk array. By
default, the array type to be created is RAID 5.
Before you start:
The RAID function should be enabled, refer to section
12-2
for details.
As the default array type is RAID 5, install at least three HDDs in your device.
If more than 10 HDDs are installed, two arrays can be configured.
1. Access the RAID configuration screen:
Menu -> HDD -> RAID
Figure 12-3 Physical Disk Screen
2. Check the checkbox for the corresponding HDD No. to select it.
3. Click the One-touch Create button to enter the One-touch Array
Configuration screen.
ISSUE 1.0
1.1 Enable RAID on page
12-3