Configuring More Settings; Figure 11-14 Snmp Settings Screen; Figure 11-15 More Settings Screen - NEC NRS Expanded Series Configuration Manual

ISSUE 1.0

2.6 Configuring More Settings

11-12

Figure 11-14 SNMP Settings Screen

3. Check the SNMP checkbox to enable this feature.
4. Configure the following SNMP settings:
Trap Address: IP Address of SNMP host.

Trap Port: Port of SNMP host.

5. Click Apply to save and exit the screen.
Before setting the SNMP, download the SNMP software and
manage to receive the device information using the SNMP port. By
setting the Trap Address, the NVR is allowed to send the alarm event
NOTE and exception message to the surveillance center.
1. Access the Network settings screen:
Menu -> Configuration -> Network
2. Select the More Settings tab to enter the More Settings screen.

Figure 11-15 More Settings Screen

3. Configure the remote Alarm Host IP/Port, Server Port, HTTP Port,
Multicast IP and RTSP Port.
Alarm Host IP/Port: With a remote alarm host configured, the device

sends the alarm event or exception message to the host when an alarm is
triggered. The remote alarm host must have the CMS (Client
Management System) software installed.
The Alarm Host IP refers to the IP address of the remote PC on which
the CMS (Client Management System) software is installed. The Alarm
Host Port must be the same as the alarm monitoring port configured in
the software (default port is 7200).
Network Settings