HEIDENHAIN 548431-05 User Manual page 617

Organization mode of operation | Parameters
Settings for fixed cycles and units
Traverse/longitudinal ratio, outside [PLVA] (602222)
Ratio for the decision to perform longitudinal or traverse machining
Traverse/longitudinal ratio, inside [PLVI] (602223)
Ratio for the decision to perform longitudinal or traverse machining
Minimum traverse length [RMPL] (602224)
[mm]: Radius dimension for the determination of the machining type
Traverse angle deviation [PWA] (602225)
[°]: Tolerance range in which the first element is considered as a traverse element
Overhang length – outside [ULA] (602226)
[mm]: Length by which the machine performs outside roughing beyond the target
point
Overhang length – inside [ULI] (602227)
[mm]: Length by which the machine performs inside roughing beyond the target
point
Lift-off length – outside [RAHL] (602228)
[mm]: Lift-off length for smoothing variants H = 1 and H = 2
Lift-off length – inside [RIHL] (602229)
[mm]: Lift-off length for smoothing variants H = 1 and H = 2
Cutting depth reduction factor [SRF] (602230)
Factor for the reduction of the infeed (cutting depth) – for tools that do not machine
in the main machining direction
Processing
Finishing (602300)
Tool angle – outside/longitudinal [FALEW] (602301)
[°]: Tool angle for finishing tool
Point angle – outside/longitudinal [FALSW] (602302)
[°]: Point angle for finishing tool
Tool angle – outside/transverse [FAPEW] (602303)
[°]: Tool angle for finishing tool
Point angle – outside/transverse [FAPSW] (602304)
[°]: Point angle for finishing tool
Tool angle – inside/longitudinal [FILEW] (602305)
[°]: Tool angle for finishing tool
Point angle – inside/longitudinal [FILSW] (602306)
[°]: Point angle for finishing tool
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
9
617