HEIDENHAIN 548431-05 User Manual page 232

5
G47: Safety clearance
Further information:
T: Tool number – turret pocket number
G14: Tool change point
Further information:
ID: ID no.
S: Cutting speed or Constant speed
F: Feed per revolution
BP: Interval time – time span for interruption of the feed
The chip is broken by the (intermittent) interruption of the feed.
BF: Feed period – time interval until the next break
The chip is broken by the (intermittent) interruption of the feed.
A: Start angle (reference: Z axis; default: parallel to Z axis)
W: Depart.angle (reference: Z axis; default: orthogonal to Z axis)
XA, ZA: Start point blank (definition of corner point of
workpiece blank contour – evaluation only if no workpiece blank
has been defined)
XA, ZA not programmed: The workpiece blank contour is
calculated from the tool position and the ICP contour
XA, ZA programmed: Definition of the corner point of the
workpiece blank
MT: M after T: M function that is executed after the tool call T
MFS: M at beginning: M function that is executed at the
beginning of the machining step
MFE: M at end: M function that is executed at the end of the
machining step
WP: No. of spindle – Displays which workpiece spindle is used
to execute the cycle (machine-dependent)
Main drive
Opposing spindle for rear-face machining
BW: Angle in the B axis (machine-dependent)
CW: Reverse the tool (machine-dependent)
HC: Shoe brake (machine-dependent)
DF: Miscellaneous function (machine-dependent)
Type of machining for technology database access:
Roughing
232
"Safety clearance G47", Page 180
"Tool change point G14", Page 180
Teach-in | Turning cycles
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017