HEIDENHAIN 548431-05 User Manual page 468

6
Line at angle on lateral surface
Programming a line at an angle:
Select the line direction
Enter the line dimensions
Define the transition to the next contour element
Parameters:
Z: Target point
Zi: Target point (incremental)
CY: Target point as linear dimension (reference: diameter XS)
CYi: Target point (incremental) as linear dimension (reference:
diameter XS)
P: Target point (in polar coordinates)
C: Target point (polar angle)
Ci: Target point (polar angle, incremental)
AN: Angle to the Z axis (for direction of angle, see help graphics)
ANn: Angle to the subsequent element
ANp: Angle to the previous element
L: Line length
F:
Further information:
ICP generates a G111 in smart.Turn mode of operation.
468
"Machining attributes", Page 418
ICP programming | Contour elements on lateral surface
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017