HEIDENHAIN 548431-05 User Manual page 295

Teach-in | Recessing cycles
ICP-Recess turning long.
Select Recessing cycle
Select Recess turning
Select ICP-Recess turning long.
The cycle machines the defined area.
Further information: "Recess turning", Page 279
If you are machining
the Start point—not the Start point blank. The
cycle machines the area defined by the Start point
and the ICP contour, taking the oversizes into
account
If you are machining
the Start point and the Start point blank. The
cycle machines the area defined by the Start point
blank and the ICP contour, taking the oversizes into
account
Cycle parameters:
X, Z: Start point
X1, Z1: Start point blank
FK: No. of ICP finished part – name of contour to be machined
P: Feed depth – Maximum infeed depth
O: Recessing feed (default: active feed rate)
I, K: O-size X and Z
SX, SZ: Cutting limit in X and Z
Further information:
B: Offset width (default: 0)
U: Unidir. turning (default: 0)
0: Bidirectional
1: Unidirectional
T: Tool number – turret pocket number
G14: Tool change point
Further information:
ID: ID no.
S: Cutting speed or Constant speed
F: Feed per revolution
A: Start angle (default: opposite to recessing direction)
W: Depart.angle (default: opposite to recessing direction)
G47: Safety clearance
Further information:
MT: M after T: M function that is executed after the tool call T
MFS: M at beginning: M function that is executed at the
beginning of the machining step
MFE: M at end: M function that is executed at the end of the
machining step
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
descending contours,
ascending contours,
"Cutting limits SX, SZ", Page 180
"Tool change point G14", Page 180
"Safety clearance G47", Page 180
define
define
5
295