HEIDENHAIN 548431-05 User Manual page 147

Machine mode of operation | Program run submode
Block scan (mid-program startup) is not available for
Reference machining operations required during
(optional) load monitoring.
No.pieces
Refer to your machine manual.
This feature must be enabled and adapted by the
machine tool builder.
If you predefine the number of pieces to be machined, the control
will run the program until the specified quantity is reached.
Defining No.pieces:
Select the Flow menu item
Select the No.pieces menu item
The control opens the No.pieces form.
Cycle parameters:
MP: Default unit quantity
P: Actual unit quantity
With the Delete qty. parts soft key, you can reset the workpiece
counter.
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
4
147