HEIDENHAIN 548431-05 User Manual page 609

Organization mode of operation | Parameters
General settings
REFIST: Actual value
REF.NOML.: Nominal value
LAG: Servo lag
DIST: Distance to go
File preview during program selection(604804)
TRUE: File preview during program selection is displayed
FALSE: No file preview during program selection
Do not display limit switch warnings (604805)
TRUE: If an axis is positioned on the limit switch position, no limit switch warning
will be displayed
FALSE: A limit switch warning will be displayed
System
Settings for automatic operation (601800)
Tool life management (601801)
On: Tool life management is active
Off: Tool life management is inactive
Program run with the most recently selected cycle (601809)
On: When Program Run is selected, the most recently selected cycle remains active.
Off: When Program Run is selected, the first cycle will be active.
End mid-program startup after start block (601810)
TRUE: In mid-program startup, program execution begins with the following NC
block
FALSE: In mid-program startup, program execution begins with the selected NC
block
Special dimensioning of button tools (601812)
On: When you enter a tool angle of 90 degrees, the tool tip of a button tool that has
no neutral tool orientation (TO not equal to 2, 4, 6, 8), will be dimensioned like a
neutral tool
Off: When you enter a tool angle of 90 degrees, the tool tip of a button tool that
has no neutral tool orientation (TO not equal to 2, 4, 6, 8), will be dimensioned with
respect to the point on the tool tip that corresponds to the orientation
Automatic program selection (601814)
On: When you activate Program Run mode of operation, the program that was last
active will be selected
Off: When you activate Program Run mode of operation, the program that was last
active will not be selected
System
Tool dimensioning (604600)
Measuring feed rate (604602)
[mm/min]: Feed rate for the approach of the touch probe
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
9
609