HEIDENHAIN 548431-05 User Manual page 274

5
In this cycle you can specify how the floor element is
machined during the finishing process.
The control evaluates the recessFinishing (602414)
machining parameter for this purpose. If this parameter
is not defined, the floor element is divided in the center.
Cycle run:
1 Calculate the recess positions and the proportioning of cuts
2 Approach the workpiece for the next recess on a paraxial path
from the Start point or from the last recess
3 Machine along the defined contour
4 Return and approach for the next pass
5 Repeat 3 to 4 until the complete recess has been machined
6 Repeat 2 to 5 until all recesses have been machined
7 Return to the Start point on a paraxial path
8 Move to the Tool change point according to the setting in G14
274
Teach-in | Recessing cycles
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017