HEIDENHAIN 548431-05 User Manual page 200

5
Cycle run:
1 Calculate the proportioning of cuts (infeed)
2 Approach the workpiece from the Start point for the first pass
3 Move to the End point contour Z2 at the programmed feed
rate
4 The contour is machined according to the setting in Contour
smoothing H
5 Retract and approach for the next pass
6 Repeat 3 to 5 until the Start point contour X1 is reached
7 Return to the Start point on a diagonal path
8 Move to the Tool change point according to the setting in G14
200
Teach-in | Turning cycles
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017