HEIDENHAIN 548431-05 User Manual page 385

Teach-in | Milling cycles
Cycle run:
All versions:
1 Activate the C axis and position at Spindle angle C at rapid
traverse (only in Teach-in submode)
2 Calculate the proportioning of cuts (infeeds to the milling planes,
infeeds in the milling planes)
3 Move to Safety clearance and plunge to the first milling plane
Roughing:
4 Machine the milling plane, taking Mill direction J
(unidirectional or bidirectional) into account
5 Plunge to the next milling plane
6 Repeat 4 to 5 until the milling depth is reached
Finishing:
4 Finish-machine the edge of the island—one working plane
after the other
5 Finish-machine the floor from the outside towards the inside
All versions:
7 Position to the Start point Z and deactivate the C axis
8 Move to the Tool change point according to the setting in G14
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
5
385