HEIDENHAIN 548431-05 User Manual page 151

Machine mode of operation | Program run submode
Resuming a job after an interruption:
Select the interrupted job
Press the Interrupt program soft key
The control marks the interrupted program.
The control sets the workpiece counter to the
number of pieces already machined.
Press the NC start key
Changing the job display:
The desired job must have been selected
The cursor is located at the selected program to be started
Select the Display menu item
Select the Switch off job list menu item
This menu item switches to the NC program
display.
Alternative: Select the Switch on job list menu
item
This menu item switches to the job display.
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
4
151