Icp Workpiece Blank Contour - HEIDENHAIN 548431-05 User Manual

5

ICP workpiece blank contour

Select Define workpiece blank
Select ICP workpiece blank contour
The cycle describes the workpiece blank and the setup used. This
information is evaluated in the Simulation submode.
Cycle parameters:
X: Chuck diameter
Z: Chuck position in Z
B: Clamp range
J: Clamp type
0: Not clamped
1: Externally clamped
2: Internally clamped
RK: ICP contour number
WP: No. of spindle – Displays which workpiece spindle is used
to execute the cycle (machine-dependent)
Main drive
Opposing spindle for rear-face machining
RG: Activate contour follow-up – Contour follow-up for Teach-
in submode
Further information:
Page 174
0: Without contour follow-up
1: With contour follow-up
182
"Contour follow-up in Teach-in submode",
Teach-in | Workpiece blank cycles
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017